Artificial grass has been the choice of millions of homeowners, businesses, and institutions around the world. For those who cannot afford natural grass, artificial grass is a good alternative. However, not all artificial grass is created equal. Learn why it may be a better option for you to have installed instead.
If you want to know how to install artificial grass Adelaide, start by reading the following step-by-step guide on how to sub-base your artificial grass installation. This is probably the cheapest method to lay artificial grass on your property. You do not have to call artificial turf installation firms since there’s an easy way to set up artificial grass on your own. Just follow along with the sub-base installation process, and soon you’ll have an amazing artificial grass yard at no extra cost.
Before starting your project, make sure that the sub-base material is firmly pressed into the ground. If you notice that there’s any bulge on the surface, you should immediately rip it away. Start by excavating the area where the turf will be installed. It would help if you used a drill bit to punch a series of holes on the ground’s topmost layer. After that, use the spade to roll out the sub-base material.
As mentioned above, this is one of the simplest ways to install synthetic grass on your property. The process only requires you to have enough space and a shovel. You can choose to have it installed on your lawn or to hire professionals. Either way, you’ll just be doing the job right. Here’s what you need to do:
Start installing by digging a series of holes equal to the cross-section of your yard. This will serve as the infill. Place the infill in the holes, making sure that you dig them to the grass base. Then, begin trowelling the infill in. Continue towing it in until the area has been completely covered. When finished, set up your trowel and install the artificial turf.
Now, if you want to save time and money on installation, you can skip the grass altogether and use stakes to place the infill over the lawn’s seams. By eliminating the grass, you can avoid having to cut the seams and spread adhesive. If you want to install artificial grass on your lawn, you can follow these steps:
Cut the sub-base material. If you’re installing the artificial grass Adelaide over natural grass, you need to cut through the lawn a couple of inches below the surface. For artificial turf over concrete or clay, you need to cut a few inches deeper. Then, take a utility knife and cut out the centre. Lastly, clean up the edges with a water hose.
Lay down the nails. The nails you buy should be strong enough to withstand the weight of the entire lawn and should penetrate deeply into the earth. Take a utility knife and easily penetrate at least four inches into the earth. Once the nails are in place, you’ll know you have enough bottom hole to accommodate the real turf.
Set up the installation area. To install artificial grass base material over a natural lawn, you must first create a flat and level surface. Start by setting up a standard irrigation system that is connected to an electric outlet. Then, lay down gopher wire about one foot away from the flat surface you’ve created. Now, stretch the gopher wire to its maximum length. Connect the ground wire to the four-inch-wide base pieces of infill that you have already purchased.
Anchor the turf. Now that the base is in place, lay down two small hooks near the corners of the area. Use the nails you purchased to anchor the strips together. Make sure you snap both hooks into place so they will serve as support later on. Then, start stretching the seam tape.
Seam the seams. Once you’ve sealed all the way around, you can start seaming the seams. Thread a narrow piece of cloth through the bottom seams, and then over the artificial grass stay. Remember to overlap the cloth. Now, apply pressure to the lawn until the cloth slides easily against the turf.